These ProWire Unified Power wall mount models are single and dual voltage access power systems, precision wired for Mercury controllers. ProWire enables the specification and installation of standardized access power equipment across an enterprise for uniform operation, maintenance and servicing.

The C8 or M8 control modules provide sixteen access control inputs capable of voltage or dry contact activation, and sixteen outputs programmable for failsafe / failsecure operation at either 12 or 24 VDC and controlled by the power supply fire alarm interface. The D8 modules provide sixteen auxiliary outputs. In dual voltage systems, each output is configurable for 12 or 24VDC operation.

Specifications

Power Supplies

• FPO150 Power supply board 12A/12V, 150W
• FPO250 Power supply board 10A/24V, 250W
• Input 120/230VAC 50/60Hz | Single voltage 142 Watts (1.42A) | Dual voltage 452 Watts (3.77A)
• Overload and short circuit protection
• Over temperature protection
• Polarized AC power supply disconnect

Battery Charging

• Independent built-in charger for sealed lead-acid or gel type batteries
• Microprocessor dual rate charging of 12 or 24V battery sets
• Automatic switchover to standby battery when AC fails
• Zero voltage drop when switched over to battery backup

Supervision

• AC Fault (form "C" contacts)
• System Fault (form "C" contacts)
• System Fault conditions: Low or no battery | short to earth ground | power supply failure

Distribution Modules

• D8P (X3) 16 auxiliary outputs, class 2 power limited at 2.5A per output (third D8P dedicated power to Mercury controllers)
• C8 (X2) 16 relay lock control outputs, fused at 3A per output

Enclosures

• Size - 36.00H x 30.00W x 6.50D in. (91.44 x 76.20 x 16.51 cm)
• Weight - 73 lbs.

Wiring Suffix

• P16-A - P = Panduit, 16 = Door Count, A = MR52 / EP1502

Regulatory Compliance

• UL / ULC - UL294, ULC S319
• CSA / FCC - CSA C22.2 #107.1 | FCC Part 15, CSFM